December 01, 2013

Christmas gift tutorial: kilner jar sewing kit


Ah, December… my favourite month!

I'm hoping for a little festive sparkle, bright but chilly mornings, perhaps a light fluttering of snow and plenty of much-loved traditions in the run up to the big day.

My husband's family run a brilliant secret santa system for presents. We are each allocated one person to buy for and a set budget. We all offer up suggestions on things we might like… it's a really simple way to avoid panic-buying random bits and pieces for each other.

I do like a bit of handmade Christmas gifting too… perhaps a hand-knitted or hand-sewn item or some festively wrapped sweet treats or preserves… simple makes that will only take an afternoon but will hopefully provide the recipient with plenty of Christmas cheer.

I have a few different projects in mind and I'll be sharing them on this blog in the run up to Christmas. This kilner jar sewing kit and pincushion is certainly not a new idea, but I've wanted to make one for a while and think it would make a lovely gift for a sewing enthusiast.


You'll need:
a 1/2 litre kilner jar with screw lid
a small piece of fine cotton fabric (lawn or poplin is perfect) about 16 inches square - I used Liberty tana lawn
a sheet of felt
a small handful of toy filling
a needle, thread and sewing pin
scissors
glue gun or multi-purpose glue
a selection of sewing kit items to fill the jar - needle, threads, scissors etc





1. Unscrew the two-part lid from the jar and remove the metal seal disc. Set the screw part of the lid aside. Place the disc onto the cotton fabric and draw a rough circle around the outside, approximately 2 inches larger than the disc. Cut out the circle and set aside.

2. Place the same disc onto the sheet of felt and draw around it twice so you have 2 circles the same size as the disc. Cut both of these circles and set one aside. With the other, cut around it again so it is about 1/4 inch smaller than the disc.

3. Using a small running stitch, stitch around the outside of the cotton circle approximately 1 inch from the edge. Once you reach the starting point, remove the needle but don't knot the cotton.

4. Now it's time to layer the pincushion. Lay the cotton circle onto the table and then the larger felt circle on top, followed by the toy filling and finally the metal disc. Using your finger to steady the middle of the disc, gently pull on the two cotton threads to gather. Adjust the edges until the cotton is gathered equally around the circle and then tie the two threads together in a knot and cut the excess.

5. Take the smaller felt circle and lay it over the underside of the pincushion to cover the rough edges. You will have a 1/4 inch gap to the edge of the cotton fabric, so that when you reattach the lid there will be room to screw it back into place. Pin it in the middle to keep it central and then stitch around the outside edge to secure it to the pincushion.

6. Take the screw part of the lid and run a line of glue on the underside edge (where the pincushion fabric will meet the metal). Quickly push the pincushion through and hold it in place until the glue sets against the fabric.

7. Fill your jar with sewing items and screw the lid/pincushion back into place.






10 comments:

  1. This is so, so lovely! Everything - your choice of fabric, your photos, the quality of the bits inside the jar - is so carefully thought out. It will make such a nice gift. And I did always wonder how those fabric pincushion tops were made, so thank you! x

    ReplyDelete
  2. As you say Charmaine, we have seen these before, but I have never seen one done so beautifully and with such care as yours. I am sure that the recipient will be very happy with it and make good use of it. Lovely! xx

    ReplyDelete
    Replies
    1. ah, that's very kind Amy! it took a bit of trial and error to get the pincushion to sit properly! so glad you like it! x

      Delete
  3. This is so pretty and such a lovely gift! I have seen these before but would never have known how to try and make one, thanks for sharing. Look forward to seeing your other projects too! xx

    ReplyDelete
  4. So pretty ... I really love this ... the perfect gift for a crafter ... looking forward to your other makes ... Bee xx

    ReplyDelete
  5. What a lovely gift, lucky recipient!

    ReplyDelete